Injected into the skin, they “stimulate our own cells to produce some of the things that we lose with ageing, namely the fibroblast cells, which are responsible for producing collagen and elastin,” explains Dr Ash Soni, plastic surgeon and founder of The Soni Clinic.
The unique manufacturing process, utilising a magnetic and air centrifugal mixer, ensures HyaFilia’s superiority in cohesiveness and elasticity. This, coupled with a low injection force, guarantees a smooth injection process, yielding excellent results for your clients.
any special category data you choose to disclose in response to this survey will be processed under Article nove(2)(h) - processing is necessary for the provision of health and social care treatment or the management of health or social care systems and services on the basis of domestic law
Beyond dynamic rheological measurements, the lack of standardized measurements is a challenge when attempting to compare physico‐chemical properties from different fillers. Differences in crosslinking technologies, HA concentration, particle size and degree of crosslinking across brands make the establishment of universal correlations challenging.
If you prefer clean skincare products, browse through their “Conscious seal of approval products” for vegan and cruelty-free options.
The manufacturing process used to produce HA dermal fillers involves breaking down the initial crosslinked gel into smaller HA gel fragments or particles.
superficial chemical peels, where skin cells are removed from the epidermis, are included under the green category.
Adjunctive procedures are those used alongside the primary cosmetic procedure being undertaken to assist or complement it. Examples include the use of local anaesthetic injections for numbing the body before dermal fillers are used, or the use of hyaluronidase for dissolving dermal fillers.
deep chemical peels using phenol or otherwise intended for use at the level of the read more reticular dermis (the thick bottom layer of the dermis). Deep peels remove the epidermal, upper dermal and can reach the deep dermal layers of skin, the reticular layer.
Radiofrequency uses the heat from radio waves to cause controlled tissue damage and promote cell renewal. It may be used on its own or combined with other mechanisms to tighten the skin as an anti-aging treatment.
′ value is the swelling factor: increased gel fluid uptake is usually observed for gels with lower G
Data sharing is not applicable to this article as pelo new data were created or analyzed in this study.
We’d like to set additional cookies to understand how you use GOV.UK, remember your settings and improve government services.
The September 2020 report The ugly side of beauty: improving the safety of cosmetic treatments in England, published by the Chartered Institute of Environmental Health (CIEH), found 90% of respondents to its consultation on the regulation of cosmetic interventions supported the introduction of a national licensing scheme to improve the safety of cosmetic procedures.